Send document comments to nexus7k-docfeedback@cisco.com
6-38
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 6 Configuring Port Channels
Configuring Port Channels
switch(config-if)# no lacp graceful-convergence
switch(config-if)# no shutdown
Reenabling LACP Graceful Convergence
If the default LACP graceful convergence is once again required, you can reenable convergence.
SUMMARY STEPS
1. configure terminal
2. interface port-channel number
3. shutdown
4. lacp graceful-convergence
5. no shutdown
6. copy running-config startup-config
DETAILED STEPS
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
interface port-channel number
Example:
switch(config)# interface port-channel 1
switch(config-if)
Specifies the port channel interface to configure, and
enters the interface configuration mode.
Step 3
shutdown
Example:
switch(config-if) shutdown
Administratively shuts down the port channel.
Step 4
lacp graceful-convergence
Example:
switch(config-if)# lacp
graceful-convergence
Enables LACP graceful convergence on the port
channel.
Step 5
no shutdown
Example:
switch(config-if) no shutdown
Brings the port channel administratively up.
Step 6
copy running-config startup-config
Example:
switch(config-if)# copy running-config
startup-config
(Optional) Copies the running configuration to the
startup configuration.
To Next Page
Loading...
