Send document comments to nexus7k-docfeedback@cisco.com
4-20
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 4 Configuring Layer 3 Interfaces
Feature History for Configuring Layer 3 Interfaces
• MIBs, page 4-20
• Standards, page 4-20
Related Documents
MIBs
Standards
Feature History for Configuring Layer 3 Interfaces
Table 4-2 lists the release history for this feature.
Related Topic Document Title
command syntax Cisco Nexus 7000 Series NX-OS Interfaces Command Reference,
Release 5.x
IP “Configuring IP” chapter in the Cisco Nexus 7000 Series NX-OS
Unicast Routing Configuration Guide, Release 5.x
VLANs “Configuring VLANs” chapter in the Cisco Nexus 7000 Series
NX-OS Layer 2 Switching Configuration Guide, Release 5.x
MIBs MIBs Link
• IF-MIB
• CISCO-IF-EXTENSION-MIB
• ETHERLIKE-MIB
To locate and download MIBs, go to the following URL:
http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml
Standards Title
No new or modified standards are supported by this
feature, and support for existing standards has not been
modified by this feature.
—
Table 4-2 Feature History for Configuring Layer 3 Interfaces
Feature Name Releases Feature Information
Three configurable sampling intervals for
interface statistics
4.2(1) Added the load-interval command.
Layer 3 interfaces 4.0(1) This feature was introduced.
To Next Page
Loading...
Need help?
General
