Cisco 7206 - VXR Router User Manual

Send document comments to nexus7k-docfeedback@cisco.com
6-21
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 6 Configuring Port Channels
Configuring Port Channels
Use the no channel-group command to remove the port from the channel group. The port reverts to its
original configuration. You must reconfigure the IP addresses for this port.
This example shows how to add a Layer 3 Ethernet interface 1/5 to channel group 6 in on mode:
switch# configure terminal
switch (config)# interface ethernet 1/5
switch(config-if)# no switchport
switch(config-if)# channel-group 6
This example shows how to create a Layer 3 port-channel interface and assign the IP address:
switch# configure terminal
switch(config)# interface port-channel 4
switch(config-if)# ip address 192.0.2.1/8
Configuring the Bandwidth and Delay for Informational Purposes
The bandwidth of the port channel is determined by the number of total active links in the channel.
You configure the bandwidth and delay on port-channel interfaces for informational purposes.
SUMMARY STEPS
1. configure terminal
2. interface port-channel channel-number
3. bandwidth value
4. delay value
5. exit
6. show interface port-channel channel-number
7. copy running-config startup-config
Step 5
show interface type slot/port
Example:
switch(config-router)# show interface
ethernet 1/4
(Optional) Displays interface information.
Step 6
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
(Optional) Copies the running configuration to the
startup configuration.
Command Purpose
Command Purpose
no channel-group
Example:
switch(config)# no channel-group
Removes the port from the channel group.

Cisco 7206 - VXR Router Specifications

General

Brand	Cisco
Model	7206 - VXR Router
Category	Network Router
Language	English