Cisco 7206 - VXR Router

Send document comments to nexus7k-docfeedback@cisco.com
2-55
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Monitoring the Interface Counters
SUMMARY STEPS
1. configure terminal
2. load-interval counters {{1 | 2| 3} seconds}
3. show interface interface
4. exit
5. copy running-config startup-config
DETAILED STEPS
This example shows how to set the three sample intervals for the Ethernet port 3/1:
switch# configure terminal
switch(config)# interface ethernet 3/1
switch(config-if)# load-interval counter 1 60
switch(config-if)# load-interval counter 2 135
switch(config-if)# load-interval counter 3 225
switch(config-if)#
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch#
Enters the configuration mode.
Step 2
load-interval counters {{1 | 2 | 3}
seconds}
Example:
switch(config)# load-interval
counters 1 100
switch(config)#
Sets up to three sampling intervals to collect bit-rate and
packet-rate statistics. The default values for each counter is
as follows:
1—30 seconds; 60 seconds for VLAN network interface
2—300 seconds
3—not configured
Step 3
show interface interface
Example:
switch(config)# show interface vlan
10
switch#
Displays the interface status, which includes the counters.
Step 4
exit
Example:
switch(config)# exit
switch#
Exits the configuration mode.
Step 5
copy running-config startup-config
Example:
switch# copy running-config
startup-config
(Optional) Copies the running configuration to the startup
configuration.