Send document comments to nexus7k-docfeedback@cisco.com
7-61
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 7 Configuring vPCs
Feature History for Configuring vPCs
vPCs 5.2(1) Added the auto-recovery command to improve speed and
reliability of vPC recovery after an outage. The reload
restore command is deprecated.
vPCs 5.2(1) Added the vpc orphan-ports suspend command to suspend
orphan ports on the vPC secondary device when the vPC
fails.
vPCs 5.2(1) Support increased to 528 vPCs.
vPCs 5.0(2) Added the reload restore command to configure the vPC
switch to assume its peer is not functional and to bring up
the vPC.
vPCs 5.0(2) Added the peer-switch command to enable the vPC switch
pair to appear as a single STP root in the Layer 2 topology.
vPCs 4.2(1) Support increased to 256 vPCs.
vPCs 4.2(1) Added the peer-gateway command to ensure that all
packets use the gateway MAC address of the device.
vPCs 4.2(1) Added the dual-active exclude interface-vlan command to
ensure that VLAN interfaces remain up if the vPC peer link
fails.
vPCs 4.2(1) Added the delay restore command to delay the bringup of
the vPC secondary device after reload until the routing table
can converge.
vPCs 4.1(4) Support increased to 192 vPCs.
vPCs 4.1(2) These features were introduced.
Table 7-3 Feature History for Configuring vPCs (continued)
Feature Name Releases Feature Information
To Next Page
Loading...
Need help?
General
