Cisco 7206 - VXR Router

Send document comments to nexus7k-docfeedback@cisco.com
2-49
Cisco Nexus 7000 Series NX-OS Interfaces Configuration Guide, Release 5.x
OL-23435-03
Chapter 2 Configuring Basic Interface Parameters
Configuring the Basic Interface Parameters
SUMMARY STEPS
1. configure terminal
2. interface [ethernet slot/port | interface-vlan vlan-id | loopback number | port-channel number |
tunnel number]
3. no inherit port-profile name
4. exit
5. show port-profile
6. copy running-config startup-config
DETAILED STEPS
This example shows how to remove the port profile named adam from Ethernet interfaces 7/3 to 7/5,
10/2, and 11/20 to 11/25:
switch# configure terminal
switch(config)# interface ethernet 7/3-5, 10/2, 11/20-25
switch(config-if)# no inherit port-profile adam
switch(config-if)#
Command Purpose
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
interface [ethernet slot/port | interface-vlan
vlan-id | loopback number | port channel number |
tunnel number]
Example:
switch(config)# interface ethernet 7/3-5, 10/2,
11/20-25
switch(config-if)#
Selects the range of interfaces.
Step 3
no inherit port-profile name
Example:
switch(config-if)# no inherit port-profile adam
switch(config-if)#
Removes the specified port profile from
the selected interfaces.
Step 4
exit
Example:
switch(config-ppm)# exit
switch(config)#
Exits the port-profile configuration mode.
Step 5
show port-profile
Example:
switch(config)# show port-profile
(Optional) Displays the port-profile
configuration.
Step 6
copy running-config startup-config
Example:
switch(config)# copy running-config startup-config
(Optional) Copies the running
configuration to the startup configuration.