Basic Call Handling
Cisco Unified IP Phone 7931G for Cisco Unified Communications Manager 6.0 27
Tips
• To start a secure conference, you must use a phone configured with security.
• Non-secure conferences and participants display a icon.
• Depending on how your phone is configured, if you leave a conference after initiating it, the
conference might end. To avoid this, transfer the conference before hanging up.
View a list of conference
participants
1. Press (steady) with an active conference.
2. Press ConfList.
Participants are listed in the order in which they join the conference
with the most recent additions at the top.
Get an updated list of
conference participants
While viewing the conference list, press Update.
See who started the
conference
While viewing the conference list, locate the person listed at the
bottom of the list with an asterisk (*) next to the name.
Remove any conference
participant
1. While viewing the conference list, highlight the participant’s
name.
2. Press Remove.
Drop the last party added to
the conference
While viewing the conference list, press RmLstC.
End your participation in a
standard conference
Hang up or press EndCall.
Verify that a conference call is
secure
Look for the or icon after “Conference” on the phone
screen.
Remove a non-secure
participant from a conference
While viewing the Conference List, locate the participant without the
or icon, and press Remove.
Check with your system administrator to see if non-initiators of a
conference can remove participants.
If you want to... Then...
Dit document wordt u aangeboden door TelecomHunter. Dé zakelijke Telecom webshop.
T 088 7463 444 | @ sales@TelecomHunter.nl | www.TelecomHunter.nl