Cisco 7941G - Page 125

To ChangeDescriptionOption
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
Enables and disables Link Layer
Discovery Protocol (LLDP) on the PC
port. Use this setting to force the phone to
use a specific discovery protocol. Settings
include:
• Enabled—default
•
Disabled
LLDP: PC Port
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
Enables and disables Link Layer
Discovery Protocol Media Endpoint
Discovery (LLDP-MED) on the switch
port. Use this setting to force the phone to
use a specific discovery protocol, which
should match the protocol supported by
the switch. Settings include:
• Enabled—default
•
Disabled
LLDP-MED: SW Port
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
Identifies the asset ID assigned to the
phone for inventory management.
LLDP Asset ID
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
Enables users to receive notifications of
incoming calls and answer or end calls
while working in a wireless environment.
Wireless Headset
Hookswitch Control
From Cisco Unified
Communications Manager
Administration, choose Device >
Phone > Phone Configuration.
Advertises the phone’s power priority to
the switch, enabling the switch to
appropriately provide power to the phones.
Settings include:
• Unknown—default
•
Low
•
High
•
Critical
LLDP Power Priority
From Cisco Unified
Communications Manager
Administration, choose Device >
Device Settings > Common
Device Configuration.
Displays the IP addressing mode that is
available on the phone-IPv4 only, IPv6
only, or IPv4 and IPv6.
IP Addressing Mode
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
105
Cisco Unified IP Phone Settings
Network Configuration Menu