Cisco 7941G

CHAPTER 5
Features, Templates, Services, and Users
•
Features, Templates, Services, and Users Overview, page 119
•
Telephony Features Available for Cisco Unified IP Phone, page 120
•
Product-Specific Parameters, page 144
•
Corporate and Personal Directories, page 145
•
Phone Button Templates, page 146
•
Softkey Templates, page 148
•
Enable Device Invoked Recording, page 149
•
Services Setup, page 149
•
Cisco Unified Communications Manager User Addition, page 150
•
User Options Web Page Management, page 151
•
EnergyWise Setup on Cisco Unified IP Phone, page 153
•
UCR 2008 Setup, page 156
Features, Templates, Services, and Users Overview
After you install Cisco Unified IP Phones in your network, configure their network settings, and add them to
Cisco Unified Communications Manager, you must use Cisco Unified Communications Manager Administration
to configure telephony features, optionally modify phone templates, set up services, and assign users.
This chapter provides an overview of these configuration and setup procedures. Cisco Unified Communications
Manager documentation provides detailed instructions for these procedures.
For suggestions about how to provide users with information about features, and what information to provide,
see Internal Support Web Site, on page 235.
For information about setting up phones in non-English environments, see International User Support, on
page 249.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
119