Cisco 7941G

Configuration referenceDescriptionFeature
•
Protected Device: To change the
status of a secure phone to protected,
check the “Protected Device” check
box in Cisco Unified
Communications Manager
Administration > Device > Phone >
Phone Configuration.
•
Play Secure Indication Tone: To
enable the protected phone to play a
secure or nonsecure indication tone,
set the Play Secure Indication Tone
to True. (The default is False.) You
set this option in Cisco Unified
Communications Manager
Administration > System > Service
Parameters. Select the server and
then the Unified CM service. In the
Service Parameter Configuration
window, select the option in the
Feature - Secure Tone area. (The
default is False.)
When a phone is configured as secure (encrypted and
trusted) in Cisco Unified CM, it can be given a protected
status. After that, if desired, the protected phone can be
configured to play an indication tone at the beginning of
a call.
Only protected phones hear these secure or nonsecure
indication tones. Nonprotected phones never hear tones.
If the overall call status changes during the call, the
indication tone changes accordingly. At that time, the
protected phone plays the appropriate tone.
A protected phone plays or does not play a tone under these
circumstances:
•
When the Play Secure Indication Tone option is
enabled (True):
◦
When end-to-end secure media is established
and the call status is secure, the phone plays
the secure indication tone (three long beeps
with pauses).
◦
When end-to-end nonsecure media is
established and the call status is nonsecure, the
phone plays the nonsecure indication tone (six
short beeps with brief pauses).
•
If the Play Secure Indication Tone option is disabled,
no tone is played.
Secure and Nonsecure
Indication Tone
For more information about security, see
Supported Security Features, on page 14.
For additional information, see:
•
Cisco Unified Communications
Manager System Guide, “Conference
Bridges” chapter
•
Cisco Unified Communications
Manager Administration Guide,
“Conference Bridge Configuration”
chapter
•
Cisco Unified Communications
Manager Security Guide.
Allows secure phones to place conference calls using a
secured conference bridge.
As new participants are added by using Confrn, Join,
cBarge, Barge softkeys or MeetMe conferencing, the secure
call icon displays as long as all participants use secure
phones.
The Conference List displays the security level of each
conference participant. Initiators can remove non-secure
participants from the Conference List. Non-initiators can
add or remove conference participants if the Advanced
Adhoc Conference Enabled parameter is set.
Secure Conference
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
139
Features, Templates, Services, and Users
Telephony Features Available for Cisco Unified IP Phone