•
Advertise G.722 Codec: From Cisco Unified Communications Manager Administration, choose System
> Enterprise Parameters. The default value of this enterprise parameter is True, which means that all
Cisco Unified IP Phone models that are described in this administration guide and are registered to this
Cisco Unified Communications Manager will advertise G.722 to Cisco Unified Communications Manager.
For more information, see the Cisco Unified Communications Manager System Guide, “Cisco Unified
IP Phones” chapter.
•
Advertise G.722 Codec: From Cisco Unified Communications Manager Administration, choose Device
> Phone. The default value of this product-specific parameter is to use the value specified in the enterprise
parameter. If you want to override this on a per-phone basis, choose Enabled or Disabled in the advertises
G.722 Codec parameter on the Product Specific Configuration area of the Phone Configuration window.
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
167
Cisco Unified IP Phone Customization
Wideband Codec Setup