Cisco 7941G Administration Guide

DescriptionItem
Total number of unicast packets received by the phoneRx unicast
Total number of frame check sequence (FCS) error packets or Align error packets
received that are less than 64 bytes in size
Rx shortErr
Total number of good packets received that are less than 64 bytes sizeRx shortGood
Total number of good packets received that are greater than 1522 bytes in sizeRx longGood
Total number of FCS error packets or Align error packets received that are greater
than 1522 bytes in size
Rx longErr
Total number of packets received, including bad packets, that are between 0 and 64
bytes in size
Rx size64
Total number of packets received, including bad packets, that are between 65 and 127
bytes in size
Rx size65to127
Total number of packets received, including bad packets, that are between 128 and
255 bytes in size
Rx size128to255
Total number of packets received, including bad packets, that are between 256 and
511 bytes in size
Rx size256to511
Total number of packets received, including bad packets, that are between 512 and
1023 bytes in size
Rx size512to1023
Total number of packets received, including bad packets, that are between 1024 and
1518 bytes in size
Rx size1024to1518
Total number of packets dropped due to lack of resources (for example, FIFO overflow)Rx tokenDrop
Total number of packets delayed from transmitting due to medium being busyTx excessDefer
Number of times that collisions occurred later than 512 bit times after the start of
packet transmission
Tx lateCollision
Total number of good packets (multicast, broadcast, and unicast) received by the phoneTx totalGoodPkt
Total number of collisions that occurred while a packet was being transmittedTx Collisions
Total number of packets not transmitted because the packet experienced 16 transmission
attempts
Tx excessLength
Total number of broadcast packets transmitted by the phoneTx broadcast
Total number of multicast packets transmitted by the phoneTx multicast
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
202
Remote Monitoring
Access and Network Area Fields

Cisco 7941G Specifications

General

Keypad number of keys	12
Touchscreen	-
Display resolution	320 x 222 pixels
Speakerphone	Yes
Voice codecs	G.729a
Bluetooth	No
Supported network protocols	DHCP, TFTP, SCCP, DSCP
Ethernet LAN (RJ-45) ports	2
Input voltage	48 V
Dimensions (WxDxH)	266.7 x 152.4 x 203.2 mm
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Handset type	Wired handset
Product type	IP Phone
Product color	Gray
Safety	(UL) 60950, (CSA) C22.2 No. 60950, IEC 60950, EN 60950, AS/NZS 60950
Certification	CE (FCC) 15 (CFR 47) B ICES-003 B EN55022 B CISPR22 B AS/NZ 3548 B VCCI B EN55024 EN 50082-1 EN 61000-3-2 EN 61000-3-3
Compliance industry standards	IEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.3af
Lines quantity	- lines
Phonebook capacity	- entries
Number of handles included	1 pc(s)

Weight and Dimensions

Weight	1600 g