Network Configuration Menu OptionDescriptionCategory
Domain NameIf you do not use DHCP in your
network, you can make IP settings
manually.
IP settings
IP Address
Subnet Mask
Default Router 1-5
DNS Server 1-5
Alternate TFTPIf you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You
can also assign an alternative TFTP
server to use instead of the one
assigned by DHCP.
TFTP settings for
TFTP IPv4 servers
TFTP Server 1
TFTP Server 2
IPv6 Network Settings
DHCPv6Dynamic Host Configuration
Protocol (DHCP) automatically
assigns IP address to devices when
you connect them to the network.
Cisco Unified IP Phones enable
DHCP by default.
DHCP settings
DHCPv6 Address Released
Domain NameIf you do not use DHCP in your
network, you can make IP settings
manually.
IP settings
IPv6 Address
IPv6 Prefix Length
IPv6 DNS Server 1-2
IPv6 Alternate TFTPIf you do not use DHCP to direct the
phone to a TFTP server, you must
manually assign a TFTP server. You
can also assign an alternative TFTP
server to use instead of the one
assigned by DHCP.
TFTP settings for
TFTP IPv6 servers
(SCCP phones only)
IPv6 TFTP Server 1
IPv6 TFTP Server 2
Related Topics
Display Settings Menu, on page 60
Unlock and Lock Options, on page 60
Value Input Guidelines, on page 61
Network Configuration Menu, on page 64
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
63
Cisco Unified IP Phone Settings
Phone Setup Options