2-15
Cisco SIP IP Phone 7960 Administrator Guide
78-10497-02
Chapter 2 Getting Started with Your Cisco SIP IP Phone
Installing the Cisco SIP IP Phone
•
When configuring a domain name:
–
Press the Number soft key if entering a numerical ID or press the Alpha
soft key to enter a name.
–
If entering letters, use the numbers on the dial pad associated with a
particular letter. For example, the 2 key has the letters A, B, and C. For a
lower case “a”, press the 2 key once. To scroll through the available
letters and numbers, press the key repeatedly.
–
Press the << soft key to delete any mistakes.
•
After making your changes, relock configuration mode as described in the
“Locking Configuration Mode” section on page 3-2.
•
For a complete list of the SIP parameters that you can configure, see the
“Modifying the Phone’s Network Settings” section on page 3-2.
Procedure
Step 1
Press the settings key. The Settings menu is displayed.
Step 2
Highlight Network Configuration.
Step 3
Press the Select soft key. The Network Configuration menu is displayed.
Step 4
Highlight DHCP Enabled.
Step 5
Press the No soft key. DHCP is now disabled.
Step 6
Highlight and configured each of the following parameters:
•
IP Address—IP address of the phone.
•
Subnet Mask—IP subnet mask used by the phone.
•
TFTP Server—IP address of the TFTP server from which the phone
downloads its configuration files and firmware images.
•
Default Routers 1 through 5—IP address of the default gateway used by the
phone. Default Routers 2 through 5 are the IP addresses of the gateways that
the phone will attempt to use as an alternate gateway if the primary gateway
is not available.
To Next Page
Loading...
Need help?
General
