Cisco 7960 - Modifying the Phone-Specific SIP Configuration File

3-15
Cisco SIP IP Phone 7960 Administrator Guide
78-10497-02
Chapter 3 Managing Cisco SIP IP Phones
Modifying the Phone’s SIP Settings
Step 2
Save the file with the same file name, SIPDefault.cnf, to the root directory of your
TFTP server.
The following is an example of a SIP default configuration file:
; sip default configuration file
#Image Version
image_version:P0S3
xxyy ;
#Default Codec
preferred_codec :g711ulaw
#Enable Registration
proxy_register :1 ;
#Registration expiration
timer_register_expires :3600 ;
#Proxy address
proxy1_address: 192.168.1.1 ;
Modifying the Phone-Specific SIP Configuration File
In the phone-specific SIP configuration file, maintain those parameters that are
specific to a phone such as the lines configured on a phone and the users defined
for those lines.
Before You Begin
•
Review the guidelines and restrictions documented in the “Configuration File
Guidelines” section on page 2-6.
•
Line parameters (those identified as linex) define a line on the phone. If you
configure a line to use an e-mail address, that line can be called only using an
e-mail address. Similarly, if you configure a line to use a number, that line can
only be called using the number. Each line can have a different proxy
configured.