3-29
Cisco SIP IP Phone 7960 Administrator Guide
78-10497-02
Chapter 3 Managing Cisco SIP IP Phones
Erasing the Locally-Defined Settings
Procedure
Step 1
Press the settings key. The Settings menu is displayed.
Step 2
Highlight Network Configuration.
Step 3
Press the Select soft key. The Network Configuration settings are displayed.
Step 4
Highlight Erase Configuration.
Step 5
Press the Ye s soft key.
Step 6
Press the Save soft key. The phone programs the new information into Flash
memory and resets.
Erasing the Locally-Defined SIP Settings
When you erase the locally-defined SIP settings, the values are reset to the
defaults.
Note
If your system has been set up to have the phones retrieve their SIP
parameters via a TFTP server, you will need to edit the configuration
file in which a parameter is defined to delete the parameter. When
deleting a parameter, leave the variable in the file, but change its
value to a null value ““ ”” or “UNPROVISIONED”. If both the
variable and its value are removed, the phone will use the setting for
that variable that it has stored in Flash memory.
Before You Begin
Unlock configuration mode as described in the “Unlocking Configuration Mode”
section on page 3-2.
Procedure
Step 1
Press the settings key. The Settings menu is displayed.
Step 2
Highlight SIP Configuration.
Step 3
Press the Select soft key. The SIP Configuration settings are displayed.
To Next Page
Loading...
Need help?
General
