Cisco 7961G Administration Guide

Chapter 2 Preparing to Install the Cisco IP Phone on Your Network
Adding Phones to the Cisco CallManager Database
2-14
Cisco IP Phone Administration Guide for Cisco CallManager, Cisco IP Phone 7961G/7961G-GE and 7941G/7941G-GE
OL-6966-01
Note When you configure the cluster for mixed mode through the Cisco CTL client,
auto-registration is automatically disabled. When you configure the cluster for
non-secure mode through the Cisco CTL client, auto-registration is automatically
enabled.
Refer to the Bulk Administration Tool User Guide for Cisco CallManager for
detailed instructions about BAT and about TAPS.
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Cisco CallManager Administration, page 2-14
• Adding Phones with BAT, page 2-15
Adding Phones with Cisco CallManager Administration
You can add phones individually to the Cisco CallManager database using
Cisco CallManager Administration. To do so, you first need to obtain the MAC
address for each phone.
For information about determining a MAC address, see the “Determining the
MAC Address for a Cisco IP Phone” section on page 1-20.
After you have collected MAC addresses, choose Device > Add a New Device in
Cisco CallManager Administration to begin.
For complete instructions and conceptual information about Cisco CallManager,
refer to the Cisco CallManager Administration Guide and to the
Cisco CallManager System Guide.
Related Topics
• Adding Phones with Auto-Registration, page 2-12
• Adding Phones with Auto-Registration and TAPS, page 2-13
• Adding Phones with BAT, page 2-15

Cisco 7961G Specifications

General

Brand	Cisco
Model	7961G
Category	IP Phone
Language	English