Cisco 7961G Administration Guide

Chapter 3 Setting Up the Cisco IP Phone
Verifying the Phone Startup Process
3-14
Cisco IP Phone Administration Guide for Cisco CallManager, Cisco IP Phone 7961G/7961G-GE and 7941G/7941G-GE
OL-6966-01
2. Some or all of the line keys flash amber in sequence.
Caution If the line keys flash red in sequence after flashing amber, do not power down the
phone until the sequence of red flashes completes. This sequence can take several
minutes to complete.
3. Some or all of the line keys flash green.
Normally, this sequence takes just a few seconds. However, if the phone’s
Flash memory is erased or the phone load is corrupted, the sequence of green
flashes will continue while the phone begins a software update procedure. If
the phone performs this procedure, the following buttons light to indicate
progress:
– Headset—Phone is waiting for the network and completing CDP and
DHCP configuration. (A DHCP server must be available in your
network.)
– Mute—Phone is downloading images from the TFTP server.
– Speaker—Phone is writing images to its Flash memory.
4. The LCD screen displays the Cisco Systems, Inc., logo screen.
5. These messages appear as the phone starts:
– Verifying Load (if the phone load does not match the load on the TFTP
server). If this message appears, the phone starts up again and repeats
step 1 through step 4 above.
– Configuring IP
– Updating CTL
– Updating Locale
– Configuring CM List
– Registering
6. The main LCD screen displays this information:
– Current date and time
– Primary directory number
– Additional directory numbers and speed dial numbers, if configured
– Softkeys

Cisco 7961G Specifications

General

Brand	Cisco
Model	7961G
Category	IP Phone
Language	English