2-35
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Inserting a Radio Module
Step 3 Slowly slide the radio module into the access point and ensure the module latch is properly positioned
into the radio module notch (see Figure 2-27).
Figure 2-27 Module Latch Position During Module Installation
Step 4
Use your thumb to push the module latch towards the lock position while squeezing with your fingers to
push the radio module into the access point (see Figure 2-28). Continue pushing until the latch aligns
with the Lock mark on the access point.
1 Radio module latch notch 3 Latch open position
2 Module latch
To Next Page
Loading...
