Cisco ASR 1002-HX

PurposeCommand or Action
Example:
Router> enable
Enter your password if
prompted.
Note
Displays a brief status of the interfaces that are
configured for IP.
show ip interface brief
Example:
Router# show ip interface brief
Step 2
Learn which type of Ethernet interface is on your
router.
Enters global configuration mode.configure terminal
Example:
Router# configure terminal
Step 3
Specifies the Ethernet interface and enters
interface configuration mode.
interface gigabitethernet 0
Example:
Router(config)# interface
gigabitethernet 0
Step 4
Sets a primary IP address for an interface.
ip address ip-address mask
Example:
Router(config-if)# ip address
172.16.74.3 255.255.255.0
Step 5
Enables an interface.no shutdown
Example:
Router(config-if)# no shutdown
Step 6
Returns to privileged EXEC mode.end
Example:
Router(config)# end
Step 7
Displays a brief status of the interfaces that are
configured for IP.
show ip interface brief
Example:
Router# show ip interface brief
Step 8
Verify that the interfaces are up and configured
correctly.
For comprehensive configuration information about IP routing and IP routing protocols, see the Configuring
IP Routing Protocol-Independent Feature on Cisco.com.
Note
Cisco ASR 1001-HX Router and Cisco ASR 1002-HX Router Hardware Installation Guide
83
Power Up and Initial Configuration
Gigabit Ethernet Management Interface Overview