Software Upgrade Process
ISSU Upgrade for Redundant Platforms
20
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Examples
The following example shows ISSU upgrade using subpackages on a Cisco ASR 1006 router or ASR
1013 router with a dual RP setup using the issu command set
Router# show version
Cisco IOS Software, IOS-XE Software (PPC_LINUX_IOSD-ADVENTERPRISEK9-M), Version
12.2(33)X
NA, RELEASE SOFTWARE (fc1)
<output removed for brevity>
System image file is "bootflash:packages.conf"
<output removed for brevity>
Router# s
how platform
Chassis type: ASR1006
Slot Type State Insert time (ago)
--------- ------------------- --------------------- -----------------
0 ASR1000-SIP10 ok 00:03:03
0/0 SPA-4XT-SERIAL ok 00:01:35
0/1 SPA-5X1GE-V2 ok 00:01:35
0/2 SPA-2XOC3-POS ok 00:01:36
0/3 SPA-4XT-SERIAL ok 00:01:35
1 ASR1000-SIP10 ok 00:03:03
1/0 SPA-4X1FE-TX-V2 ok 00:01:36
1/1 SPA-2X1GE-V2 ok 00:01:35
1/3 SPA-1XOC12-POS ok 00:01:36
R0 ASR1000-RP1 ok, active 00:03:03
R1 ASR1000-RP1 ok, standby 00:03:03
F0 ASR1000-ESP10 ok, active 00:03:03
F1 ASR1000-ESP10 ok, standby 00:03:03
P0 ASR1006-PWR-AC ok 00:02:07
P1 ASR1006-FAN ok 00:02:07
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------------------------
0 07091401 12.2(33r)XNB
1 07091401 12.2(33r)XNB
R0 07062111 12.2(33r)XNB
R1 07062111 12.2(33r)XNB
F0 07091401 12.2(33r)XNB
F1 07091401 12.2(33r)XNB
Router# s
how version r0 installed
Package: Provisioning File, version: n/a, status: active
File: bootflash:packages.conf, on: RP0
Built: n/a, by: n/a
Step 16
redundancy force-switchover
Example:
Router# redundancy force-switchover
Force an RP switchover to complete the upgrade.
Step 17
request platform software package clean
Example:
Router# request platform software package clean
(Optional) Removes all unused subpackages files from the
router.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
