Configuring Bridge Domain Interfaces
How to Configure a Bridge Domain Interface
9
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Router(config-if)# exit
Router(config)#
You can use different show commands to display the bridge domain interface configuration information:
• show interfaces bdi—Displays the configuration summary of the corresponding BDI.
Example:
Router# show interfaces BDI3
• show platform software interface fp active name—Displays the bridge domain interface
configuration in a Forwarding Processor.
Example:
Router# show platform software interface fp active name BDI4
• show platform hardware qfp active interface if-name—Displays the bridge domain interface
configuration in a data path.
Example:
Router# show platform hardware qfp active interface if-name BDI4
You can use the following debug commands to debug the bridge domain interface configurations:
• debug platform hardware qfp feature—Debugs the features in the Cisco Quantum Flow Processor
(QFP).
The following example shows how to debug the l2bd for all the clients:
Router# debug platform hardware qfp active feature l2bd client all
The selected CPP L2BD Client debugging is on.
• platform trace runtime process forwarding-manager module—Enables the Forwarding Manager
Route Processor and Embedded Service Processor trace messages for the Forwarding Manager
process.
In the following example, the trace le
vel for the forwarding processor module in the Forwarding
Manager of the ESP processor in slot 0 is set to the informational tracing level (info):
Router(config)# platform trace runtime slot F0 bay 0 process forwarding-manager module
interfaces level info
• platform trace boottime process forwarding-manager module interfaces—Enables the
Forwarding Manager Route Processor and Embedded Service Processor trace messages for the
Route Processor Forwarding Manager process during bootup.
In the following example, the trace le
vel for the forwarding processor module in the Forwarding
Manager of the ESP processor in slot R0 is set to the informational tracing level (max):
Router(config)# platform trace boottime slot R0 bay 1 process forwarding-manager
forwarding-manager level max
For additional information on the commands and the options available with each command, see the Cisco
IOS Configuration Fundamentals Command Reference Guide located at:
http://www.cisco.com/en/US/docs/ios/fundamentals/command/reference/cf_book.html
To Next Page
Loading...
Need help?
General
