Cisco ASR1006 - ASR 1006 Modular Expansion Base User Manual

Using Cisco IOS XE Software
Getting Help
10
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
Router(config-if)# ?
Interface configuration commands:
.
.
.
ip Interface Internet Protocol config
commands
keepalive Enable keepalive
lan-name LAN Name command
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load calculation
for an
interface
locaddr-priority Assign a priority group
logging
Configure logging for interface
loopback Configure internal loopback on an
interface
mac-address Manually set interface MAC address
mls mls router sub/interface commands
mpoa MPOA interface configuration commands
mtu Set the interface Maximum Transmission
Unit (MTU)
netbios Use a defined NETBIOS access list or
enable
name-caching
no Negate a command or set its defaults
nrzi-encoding Enable use of NRZI encoding
ntp Configure NTP
.
.
.
Router(config-if)#
Enter ? to display a list of all the interface
configuration commands available for the serial
interface. This example shows only some of the
available interface configuration commands.
Router(config-if)# ip ?
Interface IP configuration subcommands:
access-group Specify access control for packets
accounting Enable IP accounting on this interface
address Set the IP address of an interface
authentication authentication subcommands
bandwidth-percent Set EIGRP bandwidth limit
broadcast-address Set the broadcast address of an
interface
cgmp Enable/disable CGMP
directed-broadcast Enable forwarding of directed
broadcasts
dvmrp DVMRP interface commands
hello-interval Configures IP-EIGRP hello interval
helper-address Specify a destination address for UDP
broadcasts
hold-time Configures IP-EIGRP hold time
.
.
.
Router(config-if)# ip
Enter the command that you want to configure for
the interface. This example uses the ip command.
Enter ? t
o display what you must enter next on the
command line. This example shows only some of
the available interface IP configuration commands.
Table 9 Finding Command Options (continued)
Command Comment

Cisco ASR1006 - ASR 1006 Modular Expansion Base Specifications

General

Rack Units	6U
Form Factor	Rack-mountable
Operating Temperature	32 to 104°F (0 to 40°C)
Product Type	Router
Slots	6
Redundancy	Redundant Power Supply Supported
Maximum Throughput	100 Gbps
Dimensions	17.5" Width
Weight	Approximately 130 lbs (59 kg)
Interfaces/Ports	Varies by installed modules
Memory	4 GB
Storage Temperature	-40°F to 158°F (-40°C to 70°C)
Relative Humidity	5% to 95% (noncondensing)
Compliance	CE, UL