EasyManuals Logo

Cisco Catalyst 4500 Series System Message Guide

Cisco Catalyst 4500 Series
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
2-87
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
QOS Messages
PORTFANOUTASIC8X100MAN-7
Error Message C4K_PORTFANOUTASIC8X100MAN-7-LOSTPACKET:[char] port [dec] lost a
packet
Explanation
A loopback packet was lost during online diagnostics of this port.
Recommended Action This is an informational message only. No action is required.
QOS Messages
This section contains the quality of service (QOS) message.
Error Message C4K_QOS-4-OUTOFPOLICERRESOURCES:Out of memory to allocate a policer
Explanation The software failed to allocate memory for a policer while processing the QoS
configuration, possibly because the policer configuration exceeded its maximum supported limit.
Recommended Action Remove policers from other unwanted policies, and retry the operation. Resend
the command when other Telnet sessions are not sending debugging commands.
REDUNDANCY Messages
This section contains the supervisor engine redundancy (REDUNDANCY) messages.
REDUNDANCY-1
Error Message C4K_REDUNDANCY-1-VTP_CONFIG_DISLOCATE: VTP config file must be in
default location for the system to work in SSO mode
Explanation
The system failed to reach SSO mode because the VTP configuration file is not i n the
default location. In a catalyst 4500 switch, the default VTP configuration file is
cat4000_flash:vlan.dat.
Recommended Action Reset the standby supervisor and remove the VTP filename configuration by
using the no vtp file command.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals