2-15
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
COMMONSTUBMAN Messages
Error Message
Error Message C4K_COMMONHWACLMAN-4-PERMITALL: Out of resources for Qos, permit all
for [object-info]
Explanation
The switch is running out of hardware CAM resources. All packets are permitted, and
QoS is applied.
Recommended Action Remove unnecessary ACLs from some interfaces.
Error Message C4K_COMMONHWACLMAN-4-PORTBASEDACLSDISABLED: Output Port Acl [char] has
been disabled on port [char]
Explanation
The output port ACL is disabled on the interface because there are not enough hardware
resources or there are ACEs that require CPU processing of packets.
The port ACL is disabled and displays a warning message because the software cannot handle the
output port ACLs.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_COMMONHWACLMAN-4-PUNTTOSOFTWARE:Out of resources, punt packets to
sw for [object-info]
Explanation The hardware content-addressable memory (CAM) resources have been depleted. The
hardware forwards the packets to the software for ACL processing.
Recommended Action Remove unnecessary ACLs from some interfaces.
COMMONSTUBMAN Messages
This section contains the Catalyst 4500 series ASIC-specific messages.
C4K_COMMONSTUBMAN-4
Error Message C4K_COMMONSTUBMAN-4-DIAGSFAILED: [char] failed diagnostics
Explanation
An ASIC in slot [char] failed diagnostics.
Recommended Action Contact your technical support representative.