Cisco Catalyst 4500 Series System Message Guide

2-14
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
COMMONHWACLMAN Messages
COMMONHWACLMAN Messages
This section contains the common hardware ACL management (COMMONHWACLMAN) messages.
COMMONHWACLMAN-4
Error Message C4K_COMMONHWACLMAN-4-ALLACLINHW: All configured ACLs now fully loaded
in hardware TCAM - hardware switching / QoS restored
Explanation
All ACL-based features are now successfully loaded. Packets that were previously
processed in software due to the prior loading failure will now be processed in hardware.
Note If the features were policy maps, then QoS will be reenabled on all applicable interfaces.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_COMMONHWACLMAN-4-HWPROGSUCCESS: [char] [char] - now fully loaded
in hardware
Explanation
ACL-based features are now successfully loaded. Packets that were previously
processed in software due to a prior loading failure will now be processed in hardware. If the feature
is a policy map, then QoS will be reenabled on the specific interface.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_COMMONHWACLMAN-4-OUTOFPATHS: Could not allocate path for
( [object-info])
Explanation
There are too many ports or VLANs using ACLs. The ACLs might not work correctly.
Recommended Action Remove unnecessary ACLs from some interfaces.
Error Message C4K_COMMONHWACLMAN-4-OUTOFLABELS: No more free labels available for
path ([object-info])
Explanation A new label could not be assigned for a new ACL. There are too many labels being used.
As a result, security ACLs will be applied in software, and will not apply the QoS feature. Maybe
too many distinct features using ACLs have been configured, or too many per-port per-vlan features
using ACLs have been configured. Hardware will forward the packets to the CPU for ACL
processing.
Recommended Action Detaching and reattaching ACLs or policies may help in some cases.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E