2-40
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
HWNETFLOWMAN Messages
HWNETFLOWMAN Messages
This section contains the NetFlow Manager (HWNETFLOWMAN) messages.
HWNETFLOWMAN-3
Error Message C4K_HWNETFLOWMAN-3-NETFLOWSTOPPED:Too many netflow parity errors
encountered. It is very likely that this is bad Netflow hardware. Stopping all
netflow related activities.
Explanation
The supervisor engine received too many parity errors from the NetFlow Services Card.
The supervisor engine stops all NetFlow-related activities after issuing this message.
Recommended Action Contact your technical support representative.
HWNETFLOWMAN-4
Error Message C4K_HWNETFLOWMAN-4-HARDWAREUNRESPONSIVE: Netflow Hardware too slow in
responding to software requests
Explanation
Software tried to access NetFlow hardware but there was no response. Typically this
would indicate that the NetFlow related hardware may have gone bad.
Recommended Action Contact your technical support representative.
Error Message C4K_HWNETFLOWMAN-4-ERRORADDRS:Netflow Fatal Error Info: Interrupt
Status ( [dec] ), FDT1 Err Addr ( [dec] ), FDT2 Err Addr ( [dec] ), FLD Err
Addr ( [dec] )
Explanation
A fatal NetFlow error occurred. The message contains critical information that can help
you determine if the NetFlow hardware is functioning properly or is bad.
Recommended Action Contact your technical support representative.
Error Message C4K_HWNETFLOWMAN-4-FATALERRORINTERRUPTSEEN: Netflow Fatal Error
interrupt seen
Explanation The NetFlow Services Card sent a fatal interrupt call to the supervisor engine, which
can crash the service card, the supervisor engine, and the entire switch. This condition is extremely
rare.
Recommended Action Contact your technical support representative.