Cisco Catalyst 4500 Series System Message Guide

2-125
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
TRANSCEIVER Messages
SYSMAN-3
Error Message C4K_SYSMAN-3-LINECARDDIAGSFAILED:Module in slot [dec] failed online
diagnostics. Please use 'show diagnostics result module [dec]test <tid> detail'
command for details.
Explanation
A module failed online diagnostics. When this occurs, all the module’s ports are flagged
as faulty and cannot be used until the problem is resolved.
Recommended Action Remove and reinsert the module. If the problem persists, copy the message
exactly as it appears on the console or in the system log, contact your technical support
representative, and provide the representative with the gathered information.
Error Message C4K_SYSMAN-3-LINECARDDIAGSPARTIALFAILURE:Partial failure on module
[dec]. Please use 'show diagnostics result module [dec]test <tid> detail' command
for details.
Explanation
Some of the module’s ports have failed online diagnostics.
Recommended Action Remove and reinsert the switch. If the problem persists, copy the message
exactly as it appears on the console or in the system log, contact your technical support
representative, and provide the representative with the gathered information.
SYSMAN-4
Error Message C4K_SYSMAN-4-MORETHANONEDEBUGCOMMANDEXECUTING:Cannot execute '[char]'
right now, please try again later
Explanation More than one Telnet session issued a debugging command at the same time. Only one
Telnet session can issue a debugging command at the same time. All Telnet sessions receive this
message, except the Telnet session that issued the command first.
Recommended Action Try the command when other Telnet sessions are not issuing debugging
commands.
TRANSCEIVER Messages
This section contains the TRANSCEIVER subsystem messages.
Error Message TRANSCEIVER-3-INTERNAL_ERROR: [char]
Explanation
The TRANSCEIVER subsystem encountered an internal software error. The error
message contains text that can be used to help identify the cause of the problem.
Recommended Action Contact your technical support representative.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E