EasyManuals Logo

Cisco Catalyst 4500 Series System Message Guide

Cisco Catalyst 4500 Series
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #55 background imageLoading...
Page #55 background image
2-37
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
HWACLMAN Messages
Error Message C4K_HW-3-X2OUIREGREADFAILURE:Error while reading Supervisor X2 OUI
register Device Addr: [dec]
Explanation
There was an unexpected error when accessing a hardware device with the given device
address.
Recommended Action Contact your technical support representative. You will probably need to
replace the supervisor engine.
Error Message C4K_HW-3-X2LOOPBACKFAILURE: Failed to put [char] Xaui([dec]) [char]
loopback
Explanation
Software was unable to put the X2 in or out of loopback because it was unable to
determine the X2 type.
Recommended Action This is an informational message only. No action is required.
HWACLMAN Messages
This section contains the hardware ACL Manager (HWACLMAN) messages.
Error Message C4K_HWACLMAN-4-ACLHWPROGERR: [input/output] [char] - hardware TCAM
limit, [char]
Explanation Some ACL-based features cannot be fully programmed into the hardware. Packets that
use these features complete processing in the software. If the feature is a policy map, then QoS is
completely disabled (on the specific interface).
This message lists the impacted feature; further messages list the specific failure that occurred.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_HWACLMAN-4-ACLHWPROGERRREASON:[input/output] [object-info]
[char] - [char]
Explanation This message provides a specific failure that prevented ACL-based features from being
fully programmed into the hardware.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_HWACLMAN-4-CAMAUDIT: ACL/QOS CAM Health Check: [input/output]
[char] Index: [dec] [char] (Cumulative Error Count: [dec] )
Explanation
The background system health monitor detected a potential problem.
Recommended Action If this is a software error, the system has already corrected itself automatically
and no action is required. If this is a hardware error, power cycle the switch.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals