Cisco Catalyst 4500 Series System Message Guide

2-75
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
LPIPMAN Messages
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl . If you still require assistance,
open a case with the Technical Assistance Center via the Internet at
http://www.cisco.com/cgi-bin/front.x/case_tools/caseOpen.pl , or contact your Cisco technical
support representative.
LPIPMAN Messages
This section contains the LAN Port IP (LPIP) dynamic host policies (LPIPMAN) messages.
Error Message C4K_LPIPMAN-4-OUTOFMEMORY: Memory for constructing ACLs is not
available.
Explanation
System memory is not available to set up LPIP dynamic host policies. LPIP host policies
do not work if this log message appears.
Recommended Action To correct this problem either free some memory on the switch or upgrade the
switch with additional RAM.
PKTPROCESSING Messages
This section contains the packet processing (PKTPROCESSING) messages.
PKTPROCESSING-3
Error Message C4K_PKTPROCESSING-3-INVALIDVLAN:Packet received on invalid Vlan from
hardware. PortId [dec] [l2-header] Vlan [dec] TagType [object-info]
Explanation
The hardware sent a packet to the CPU, but the receiving VLAN was incorrect. There
is probably a hardware problem.
Recommended Action Contact your technical support representative.
Error Message C4K_PKTPROCESSING-3-OUTOFPACKETINFOTODRIVER: \"Ran out of memory to
send packet information to the driver that enqueues packets to hardware\"
Explanation
Transmit packets are probably stuck in a queue, and some of the packets have been sent
to multiple destinations. This event wastes memory, so new packet information cannot be allocated.
Recommended Action Contact your technical support representative.
Error Message C4K_PKTPROCESSING-3-OUTOFPACKETSTODRIVER: \"Ran out of memory to send
packets to the driver that enqueues packets to hardware\"
Explanation
Transmit packets are probably stuck in a queue, so new packets cannot be queued.
Recommended Action This is an informational message only. No action is required.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E