2-78
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
PM Messages
PKTPROCESSING-5
Error Message C4K_PKTPROCESSING-5-NOTAPPLYINGACL:Not applying [input/output] Acl
for packet [packet-info]
Explanation
The software is unable to determine the correct ACL entry that is indicated by the
hardware. The hardware-provided index of the ACL content-addressable memory (CAM) indicates
that the software needs to take the actions for the entry at that index. If the packet was queued in the
hardware before the software could process it, the index is out of date.
Recommended Action This is an informational message only. No action is required.
PKTPROCESSING-7
Error Message C4K_PKTPROCESSING-7-ADJLOOKUPFAILED:Draining the backed up packets in
CPU queue when we cleaned up FIB adjacencies. Last drained packet's source address
[ip-addr] and destination address [ip-addr]
Explanation
This event can occur when the software processes the routed packets and the router port
is shut down. The software can automatically repair adjacencies, but there was at least one packet
in the queue that was lost.
Recommended Action This is an informational message only. No action is required.
PM Messages
This section contains the Port Manager (PM) messages.
PM-2
Error Message PM-2-LOW_SP_MEM: Switch process available memory is less than [dec]
bytes
Explanation
The switch has insufficient memory for processing. Too many Layer 2 VLANs might
have been configured in the system.
Recommended Action Remove Layer 2 VLANs or other features from the system to reduce memory
usage.