Cisco Catalyst 4500 Series System Message Guide

2-50
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
IOSIPROUTEMAN Messages
IOSIPROUTEMAN Messages
This section contains the Catalyst 4500 series Cisco IOS IP Route Manager (IOSIPROUTEMAN)
messages.
IOSIPROUTEMAN-3
Error Message C4K_IOSIPROUTEMAN-3-ADJMANNOMOREADJS:AdjMan:
hardware adjacency resources exhausted, performance may be degraded.
Explanation
The hardware adjacency resources have been exhausted. The supervisor engine will
forward packets to this adjacency in the software. This action will likely represent a significant
performance degradation.
Recommended Action Reduce the number of adjacencies that are loaded into the routing table, and
then clear the IP routing table.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBADJ:IOS IP Route Manager:No
memory available to allocate FIB Adjacency for [object-info]
Explanation
The switch does not have sufficient memory to allocate space for this adjacency; the
supervisor engine will forward it in the software instead.
Recommended Action Reconfigure the network so that there are fewer hosts that are directly adjacent
to the Catalyst 4500 series switch, and then clear and reload all of the routes (or reboot) so that the
adjacent hosts that were being sent to the software get reloaded.
Error Message C4K_IOSIPROUTEMAN-3-FIBCANTALLOCATEFIBENTRY:IOS IP Route Manager:No
memory available to allocate FIB Entry for [ip-addr]
Explanation
The switch has insufficient memory to allocate space for the route that is associated with
this network.
Recommended Action Contact your technical support representative because memory leaks might
exist.
Error Message C4K_IOSIPROUTEMAN-3-PBRDOESNOTSUPPORTQOS:Route-map ' [char] ' on
interface ' [char] ' specifies Quality of Service rewriting which is not supported
via Policy-Based Routing on this platform. Please use the Quality of Service
feature instead. This action on the specified route map will be ignored.
Explanation
The switch does not support QoS services that are implemented using PBR route maps.
The PBR route map that is specified will be loaded, but references to QoS services will be ignored.
Recommended Action Use the QoS policy maps and class maps to configure this feature.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E