EasyManuals Logo

Cisco Catalyst 4500 Series System Message Guide

Cisco Catalyst 4500 Series
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #112 background imageLoading...
Page #112 background image
2-94
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
SPD Messages
Error Message C4K_S2W-4-STARTCALENDAROSCILLATORERR: Failed to start the calendar
Explanation
The calendar operation failed to start.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_S2W-4-WRITECALENDARERR: Calendar write operation Failed
Explanation The system was unable to write to the calendar.
Recommended Action This is an informational message only. No action is required.
SPD Messages
This section contains the SPD messages.
Error Message C4K_SPD-3-SDRAMDATAINVALID: Invalid Sdram Spd Data on DIMM module
[dec] . Total Sdram on the supervisor is [dec] MB.
Explanation
There is a SDRAM SPD data checksum error, the data is invalid.
Recommended Action Use the show platform spd sdram command for more details. If a DIMM
module is bad, it needs to be returned to Cisco for replacement.
Error Message C4K_SPD-3-SDRAMREADERROR: DIMM module [dec] Spd Read Error: [char]
. Total Sdr am on the supervisor is [dec] MB.
Explanation The system encountered a problem when reading SDRAM SPD data.
Recommended Action Use the show platform spd sdram command for more details. If a DIMM
module is bad, it needs to be returned to Cisco for replacement.
SFF8472 Messages
This section contains the floating-point subsystem (SFF8472) messages.
SFF8472-2
Error Message SFF8472-2-NOMEM: Not enough memory available for [char]
Explanation
The SFF8472 subsystem could not obtain the memory that it needed.
Recommended Action Contact your technical support representative.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals