2-79
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
PM Messages
Error Message PM-2-NOMEM:Not enough memory available for [char]
Explanation
The Port Manager subsystem cannot obtain sufficient memory for the specified PM
operation. [char] is the PM operation ID.
Error Message PM-2-VLAN_ADD:Failed to add VLAN [dec] - [char].
Explanation
The VLAN was not added to VTP, because of the reason stated in the text string.
Recommended Action This is an informational message only. No action is required.
PM-3
Error Message PM-3-ERR_INCOMP_PORT: [dec]/[dec] is set to inactive because
[dec]/[dec] is a [char] port
Explanation
The private host port cannot be configured with the trunk, private, promiscuous, and
SPAN destination port on the same coil.
Recommended Action Try to configure the incompatible ports on different coils.
Error Message PM-3-INTERNALERROR:Port Manager Internal Software Error
([char]:[char]:[dec]:[char])
Explanation
The access VLAN on the VMPS server is set to the same VLAN as a voice VLAN on
the port. The access VLAN assignment on the VMPS server should be different from the voice
VLAN.
Recommended Action Reset the VLAN assignments to remove the conflict.
PM-4
Error Message PM-4-BAD_APP_ID:an invalid application id [dec] was detected
Explanation
The Port Manager detected a request with an invalid application ID, where [dec] is the
application ID.
Recommended Action Reset the VLAN assignments to remove the conflict.
Error Message PM-4-BAD_APP_REQ:an invalid [char] request by the ‘[char]’ application
was detected
Explanation
The Port Manager detected an invalid request. The first [char] is the invalid request, and
the second [char] is the application making the request.
Recommended Action Reset the VLAN assignments to remove the conflict.