EasyManuals Logo

Cisco Catalyst 4500 Series System Message Guide

Cisco Catalyst 4500 Series
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #145 background imageLoading...
Page #145 background image
2-127
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
UFAST_MCAST_SW Messages
Error Message C4K_TRANSCEIVERMAN-3-SEEPROMREADFAILED: Failed to read transceiver
serial eeprom on port [char], try reinserting
Explanation
A transceiver with a serial EEPROM has been detected in the port referred to in the
message, but the read of the serial EEPROM's contents failed. It is necessary to read the serial
EEPROM to determine what sort of transceiver it is. Sometimes the read fails because the
transceiver is not seated correctly.
Recommended Action Try removing and reinserting the transceiver. If this message still appears after
that, try the transceiver in another port, to verify that the transceiver is bad, and not the port. If the
transceiver fails in another port, return the transceiver, as the transceiver must be reprogrammed for
it to work. If the transceiver succeeds in other ports, but not the original port, that implies that the
original port is bad, not the transceiver, and the module needs to be returned, to fix the port. As a
further test of the port, other transceivers could be tried in the suspected bad port. If these other
transceivers also fail in that port, it is very likely that the port is bad.
UFAST_MCAST_SW Messages
This section contains the UplinkFast (UFAST_MCAST_SW) messages.
UFAST-3
Error Message UFAST_MCAST_SW-3-PROC_START_ERROR:UplinkFast packets will not be
transmitted as the process could not be created.
Explanation
The UplinkFast packets will not be transmitted as the process cannot be created.
Recommended Action Reload UplinkFast. If this problem persists even after the reload, copy the
message exactly as it appears on the console or in the system log, contact your technical support
representative, and provide the representative with the gathered information.
UFAST-4
Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE:No memory is available for
transmitting UplinkFast packets on Vlan [dec].
Explanation
UplinkFast packets are not transmitted on VLAN [dec] due to a lack of memory.
Recommended Action Reduce other system activity to ease memory demands. Contact your technical
support representative to determine whether you need to upgrade to a larger memory configuration.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals