EasyManuals Logo

Cisco Catalyst 4500 Series System Message Guide

Cisco Catalyst 4500 Series
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
2-121
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
SWITCHMANAGER Messages
Error Message C4K_SWITCHINGENGINEMAN-4-SYSTEMNOTRESET: System has already been reset
[dec] times due to Packet Memory errors. System will not be reset anymore
Explanation
The software detected a large number of errors in the packet memory and reset the
switch. This condition indicates a hardware problem. However, the system only reset [dec] times by
software to prevent an auto-boot followed by a reset loop.
Recommended Action Replace the switch. If you do not replace the switch, errors may persist and the
system will reset again.
SWITCHMANAGER Messages
This section contains the Switching Manager (SWITCHMANAGER) messages.
SWITCHMANAGER-3
Error Message C4K_SWITCHMANAGER-3-DUPLICATESWPHYPORT: Internal Event: Tried to
create new sw PimPhyport [char], but it already exists
Explanation
This message is a debug message that is used by developers only and should not occur
during operation.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_SWITCHMANAGER-3-DUPLICATESWPORT: Internal Event: Tried to create
new sw PimPort [char], but it already exists
Explanation
This message is a debug message that is used by developers only and should not occur
during operation.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_SWITCHMANAGER-3-SSOACTIVEPORTACKTIMEOUT: Internal Event: timed
out after [dec] iterations waiting for Standby to acknowledge port status change
for [char]
Explanation
There is probably a software failure creating a communication problem between the
active supervisor engine and the standby supervisor engine. SSO Redundancy mode cannot operate
reliably when this condition occurs.
Recommended Action Contact your technical support representative.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals