2-48
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
IOSINTF Messages
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation
The specified Layer 3 interface does not have an assigned internal VLAN because
duplicate IP network assignments exist on different Layer 3 interfaces.
Recommended Action Remove the duplicate IP network that is configured on the interface. Assign the
correct IP network, and enter the no shutdown command on this interface.
Error Message C4K_IOSINTF-5-NOTXVLAN:Router Port [char] has no internal vlan
assigned to transmit packet
Explanation
Occasionally during hot-swapping operations a previously queued packet is transmitted
after the module in that slot was removed. Because the module no longer exists, the packets are
dropped.
Recommended Action If the problem persists even without any hot-swapping operations, contact your
technical support representative.
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETORACL: Output PACL [char] is disabled
on port [char]
Explanation
If the port is configured for an SVI that has output RACL, then the output PACL on the
port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-OUTPACLDISABLEDUETOVACL: Output PACL [char] is disabled
on port [char]
Explanation
If the port is configured for a VLAN that has output RACL, then the output PACL on
the port is disabled. Output RACL and output PACL are mutually exclusive, it is not possible to
configure both simultaneously.
Recommended Action This is an informational message only. No action is required.
Error Message C4K_IOSINTF-5-STALEPHYPORT: Dropping packets to be transmitted out on
port [char] ( Linecard in Slot [dec] may have been removed )
Explanation During hot-swapping operations a previously queued packet may be transmitted after a
switching module is removed. This indicates such packets are being dropped.
Recommended Action If this message appears without any hot swapping, please contact your
technical support representative.