2-51
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
IOSL2MAN Messages
Error Message C4K_IOSIPROUTEMAN-3-VRFMANNOMOREVRFS: VrfMan: VPN routing forwarding
resources exhausted.
Explanation
The VPN routing forwarding resources have been exhausted.
Recommended Action Reduce the total number of VPNs in the switch.
Error Message C4K_IOSIPROUTEMAN-3-WCCPINVALIDMASKASSIGNMENTTABLE: Invalid mask
assignment table received for WCCP service group [char]
Explanation
The number of distinct masks in the new mask assignment table is more the maximum
number supported for a service group on the switch. The new table is discarded. Since a valid mask
assignment table is not available anymore, the service group cannot redirect traffic. All the traffic
that was expected to be redirected is now routed normally.
Recommended Action Make sure that the cache engine is correctly configured to send a valid mask
assignment table to the switch.
IOSIPROUTEMAN-4
Error Message C4K_IOSIPROUTEMAN-4-WCCPUNCHANGEDMASKASSIGNMENTTABLE: Mask assignment
table update received but the table has not changed for WCCP service group [char]
Explanation The service group has received a new mask assignment table identical to the current
table. This could be due to a misconfiguration on the content engine side. The table change
indication will be ignored and the service group continues to use the current table for redirection.
Recommended Action Please check the configuration on the content engine side to make sure that this
unnecessary update does not get sent. If the configuration looks correct and the content engine is not
sending the same table repeatedly but you still see this message, please contact your technical
support representative.
IOSL2MAN Messages
This section contains the Catalyst 4500 series Cisco IOS Layer 2 Manager (IOSL2MAN) message.
Error Message C4K_IOSL2MAN-3-VLANCREATIONERROR:Unable to create new vlan [dec]
Explanation
The switch does not have sufficient memory to allocate new VLANs, so the new VLAN
allocation failed.
Recommended Action Contact your technical support representative because memory leaks might
exist.