Cisco Catalyst 4500 Series System Message Guide

2-128
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
VQPCLIENT Messages
VQPCLIENT Messages
This section contains VLAN Query Protocol (VQP) Client messages.
VQPCLIENT-2
Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP
Explanation
An error occurred when the system tried to allocate memory for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log,
contact your technical support representative, and provide the representative with the gathered
information.
Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars]
Explanation
The VLAN Membership Policy Server (VMPS) denied access for the given host MAC
address to an interface. [enet] is the host MAC address, and [chars] is the interface name.
Recommended Action This is an informational message only. No action is required. If you think that
the host should have been allowed access, verify the configuration on the VMPS.
Error Message VQPCLIENT-2-INITFAIL: Platform-specific VQP initialization failed.
Quitting
Explanation
An error occurred during initialization of the VQP client platform-specific code.
Recommended Action Copy the message exactly as it appears on the console or in the system log,
contact your technical support representative, and provide the representative with the gathered
information.
Error Message VQPCLIENT-2-IPSOCK: Could not obtain IP socket
Explanation
An error occurred when the system attempted to open an IP socket to the VMPS.
Recommended Action If the error message recurs, copy the message exactly as it appears on the
console or in the system log, contact your technical support representative, and provide the
representative with the gathered information.
Error Message VQPCLIENT-2-PROCFAIL: Could not create process for VQP. Quitting
Explanation An error occurred while creating a process for the VQP client.
Recommended Action Copy the message exactly as it appears on the console or in the system log,
contact your technical support representative, and provide the representative with the gathered
information.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E