2-36
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
FLASH Messages
Error Message EC-5-UNSUITABLE:[char] will not join any port-channel
Explanation
The configurations for PortFast, VMPS, and Dest-SPAN are incompatible with
EtherChannel.
Recommended Action Unconfigure the three features so that the port can form a bundle.
FLASH Messages
This section contains the Flash memory (C4K_FLASH) messages.
Error Message C4K_FLASH-4-COMPACTFLASHNOTFOUND: Cannot find compact flash
Explanation
You may see this message if the compact flash is not inserted properly or if it is removed
while the switch is trying to access the flash.
Recommended Action Reinsert the compact flash and retry the operation.
Error Message C4K_FLASH-4-COMPACTFLASHNOTREADY: Compact flash is not ready
Explanation
You may see this message if the compact flash is not inserted properly or if it is removed
while the switch is trying to access the flash.
Recommended Action Reinsert the compact flash and retry the operation.
HW Messages
This section contains the hardware (HW) messages.
Error Message C4K_HW-3-S2WERROR:[char] [char] [dec] Error: [object-info] Device
Addr: [dec] Mem Addr: [object-info] Value: [dec]
Explanation
An unexpected error occurred when the switch accessed the hardware device specified
in the message.
Recommended Action Contact your technical support representative.
Error Message C4K_HW-3-X2IDENTIFICATIONFAILURE:Error while trying to identify serdes
type for [char] ( [dec] ) X2 module
Explanation
There was an error when trying to identify the X2 module type.
Recommended Action Contact your technical support representative. You will probably need to
replace the supervisor engine.