2-124
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
SYSMAN Messages
Error Message C4K_SWNETFLOWMAN-4-NETFLOWCACHEFULL: Netflow hardware-software map
cache full. Could not create a map.
Explanation
The switch uses a map to correlate flow in the software with corresponding flows in the
hardware. This map is full and the switch cannot create any more mappings. This is a very rare
condition. The switch is running at full capacity.
Recommended Action This is an informational message only. No action is required.
SWNETFLOWMAN-6
Error Message C4K_SWNETFLOWMAN-6-FIXEDCREATIONTIME:Fixed creation time of [dec]
flows.
Explanation
The system did not record the creation time of a flow. In this case, the system
determined a creation time, which is usually the same time that was used for the last flow.
Recommended Action If this message reoccurs frequently, and you see that the system is fixing a lot
of flows, contact your technical support representative.
SYSMAN Messages
This section contains the System Manager (SYSMAN) messages.
SYSMAN-2
Error Message C4K_SYSMAN-2-POWERONSELFTESTFAIL:Supervisor module in slot [dec]
failed Power-On-Self-Test(POST). Line cards are **NOT** initialized. Please use
'show diagnostics result module [dec]test <tid> detail’ command for details.
Explanation
A power-on self test (POST) failure is detected on the supervisor engine. When this
occurs, the modules are not initialized.
Recommended Action Use the show diagnostics result module dec test tid detail command to
isolate the problem. Reset the switch after you have resolved the supervisor engine failure.
To Next Page
Loading...
Need help?
General
