Cisco Catalyst 4500 Series System Message Guide

2-27
Catalyst 4500 Series Switch Cisco IOS System Message Guide
OL-13091-01
Chapter 2 Messages and Recovery Procedures
DOT1X (802.1X) Messages
Error Message DOT1X-5-ERR_VLAN_INTERNAL: The VLAN [dec] is being used internally and
cannot be assigned for use on the Dot1x port [char] Vlan
Explanation
The VLAN is used internally and cannot be assigned on this port.
Recommended Action Update the configuration so that this VLAN is not used.
Error Message DOT1X-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot be
assigned for use on the Dot1x port [char]
Explanation
The VLAN specified is out of range and cannot be assigned on this port.
Recommended Action Update the configuration to use a valid VLAN.
Error Message DOT1X-5-ERR_VLAN_NOT_ASSIGNABLE: Port [char] cannot be authenticated
into VLAN [dec]
Explanation
Dot1x attempted to authenticate a port into a VLAN that is incompatible with the port
type, such as a regular VLAN to a PVLAN host port, a private VLAN to an access port, or any
VLAN to a routed or PVLAN promiscuous port. This can also occur when a PVLAN port has an
incomplete local configuration on the switch.
Recommended Action This is an informational message only. No action is required.
Error Message DOT1X-5-ERR_VLAN_NOT_FOUND: RADIUS tried to assign non-existent VLAN
name [char] to dot1x port
Explanation
The RADIUS server tried to assign a VLAN to a client on a port, but the VLAN name
was not found in the VTP database.
Recommended Action This is an informational message only. No action is required.
Error Message DOT1X-5-ERR_VLAN_RESERVED: The VLAN [dec] is a reserved vlan and cannot
be assigned for use on the Dot1x port [char] Vlan
Explanation
The specified VLAN is a reserved VLAN and cannot be assigned for use on this port.
Recommended Action Update the configuration so that this VLAN is not used.
Error Message DOT1X-5-ERR_VLAN_RSPAN_CONFIGURED: VLAN [dec] is configured as a
Remote SPAN VLAN
Explanation
Remote SPAN should not be enabled on a VLAN in which ports are configured with
802.1X enabled.
Recommended Action Either disable remote SPAN configuration on the VLAN, or disable 802.1X on
all the ports in this VLAN.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E