Cisco CGS 2520 User Manual

Contents
iv
Cisco CGS 2520 Hardware Installation Guide
OL-31444-01
CHAPTER 2 Switch Installation 2-1
Warnings 2-1
Installation Guidelines 2-3
Verifying Switch Operation 2-3
Installing the Switch 2-4
Mounting into a Rack 2-4
Mounting Brackets 2-4
Attaching Brackets for 19-Inch Racks 2-5
Attaching Brackets for 19-Inch Racks (IP-30 Compliance) 2-7
Attaching Brackets for 23-Inch Racks 2-12
Attaching Brackets for ETSI Racks 2-13
Mounting the Switch into a Rack 2-15
Wall-Mounting 2-16
Attaching Brackets for Wall Mounting 2-16
Wall-Mounting (for IP-30 Compliance) 2-17
Installing and Removing SFP Modules 2-19
Installing SFP Modules 2-19
Removing SFP Modules 2-20
Inserting and Removing the SFP Module Patch Cable 2-21
Removing the SFP Module Patch Cable 2-22
Replacing the SD Flash Memory Card 2-22
Connecting Devices to the Ethernet Ports 2-24
Connecting to the 10/100 and 10/100/1000 Ports 2-25
Connecting to the 10/100 PoE+ Ports 2-25
Where to Go Next 2-26
CHAPTER 3 Power Supply Installation 3-1
Power Supply Modules 3-1
Power Supply Module Installation 3-2
Installation Guidelines 3-3
Installing a Power Supply Module 3-3
Equipment That You Need 3-3
Grounding the Switch 3-4
Installing the Power Supply Module in the Switch 3-6
Wiring the Power Source 3-7
Removing the Power Supply Module 3-11

Cisco CGS 2520 Specifications

General

Brand	Cisco
Model	CGS 2520
Category	Switch
Language	English