x Cisco 4000 Series Hardware Installation and Maintenance
Figure 2-33 T1 Interface Cable 2-31
Figure 2-34 Channelized E1 Network Interface Processor 2-32
Figure 2-35 Location of Jumpers on the CE1 Module 2-33
Figure 2-36 E1 Interface Cable for 75-Ohm, Unbalanced Connections (with BNC Connectors) 2-33
Figure 2-37 E1 Interface Cable for 120-Ohm, Balanced Connections (with DB-15 Connectors) 2-34
Figure 2-38 E1 Interface Cable for 120-Ohm, Balanced Connections (with Twinax Connectors) 2-34
Figure 2-39 E1 Interface Cable for 120-Ohm, Balanced Connections (with RJ-45 Connector) 2-34
Figure 2-40 ATM Network Processor Module with STS-3c/STM-1 Single Mode PLIM 2-35
Figure 2-41 ATM Network Processor Module with STS-3c/STM-1 Multimode PLIM 2-35
Figure 3-1 Making Token Ring Connections 3-2
Figure 3-2 Making Dual-Ethernet Module Network Connections 3-3
Figure 3-3 Unsupported and Supported Single-Port Ethernet Module Connections 3-3
Figure 3-4 60-Pin Four-Port Serial Cable Connections 3-4
Figure 3-5 Making Serial Connections to the Four-Port Serial Module 3-5
Figure 3-6 Making Serial Connections to the Dual Serial Module 3-5
Figure 3-7 Four-Port BRI Network Processor Module 3-7
Figure 3-8 Eight-Port BRI Network Processor Module 3-7
Figure 3-9 Creepage and Clearance Distances between BRI Module and Components 3-10
Figure 3-10 Dual-Attachment FDDI Connections 3-12
Figure 3-11 Making Single-Attachment Multimode FDDI Connections 3-12
Figure 3-12 Single-Mode Dual-Attachment FDDI Connections 3-13
Figure 3-13 Cisco 4000 Series DC-Input Power Supply—Rear View 3-20
Figure 3-14 Cisco 4000 Series AC-Input Power Supply—Rear View 3-20
Figure 3-15 DC-Input Power Supply Connections 3-21
Figure 4-1 Cisco 4000 Series—Front Panel Indicators 4-3
Figure 4-2 Dual-Port Ethernet Network Processor Module LEDs 4-4
Figure 4-3 Single-Port Ethernet Network Processor Module LEDs 4-4
Figure 4-4 Token Ring Module Network Connector 4-5
Figure 4-5 Four-Port Serial Network Processor Module Ports 4-6
Figure 4-6 G.703/G.704 Serial Network Processor Module Ports (DB-15) 4-6
Figure 4-7 Serial Port Labeled V2 4-7
Figure 4-8 Dual Serial Network Processor Module—Top View 4-8
Figure 4-9 Dual Serial Port LED Card—Side View 4-8
Figure 4-10 Dual-Attachment Single-Mode FDDI Module—End View 4-9
To Next Page
Loading...
Need help?
General
