List of Figures xi
Figure 4-11 Dual-Attachment Multimode FDDI Module—End View 4-10
Figure 4-12 Single-Attachment Multimode FDDI Module—End View 4-10
Figure 4-13 Eight-Port BRI Network Processor Module 4-11
Figure 4-14 Four-Port BRI Network Processor Module 4-11
Figure 4-15 Channelized T1 Network Interface Processor 4-12
Figure 4-16 Channelized E1 Network Interface Processor 4-13
Figure 4-17 ATM Network Processor Module with STS-3c/STM-1 Single Mode PLIM 4-14
Figure 4-18 ATM Network Processor Module with STS-3c/STM-1 Multimode PLIM 4-14
Figure 5-1 Component Tray Removal for Chassis With a Safety Latch 5-3
Figure 5-2 Component Tray Removal for Chassis Without a Safety Latch 5-4
Figure 5-3 Typical Cisco 4000 Series Component Tray—Cisco 4000-M Shown 5-5
Figure 5-4 Network Processor Module Locations 5-6
Figure 5-5 Cisco 4000-M SIMM Locations 5-7
Figure 5-6 Cisco 4500-M and Cisco 4700 SIMM Locations 5-8
Figure 5-7 Cisco 4000 Series Main Memory SIMM 5-8
Figure 5-8 Removing Main Memory SIMMs 5-10
Figure 5-9 Installing Main Memory SIMMs 5-12
Figure 5-10 Inserting Shared-Memory SIMMs 5-15
Figure 5-11 Removing the Boot Helper Flash Memory SIMM 5-16
Figure 5-12 Inserting Flash-Memory SIMMs 5-18
Figure 5-13 Boot ROMs Locations 5-19
Figure A-1 Dual Serial EIA/TIA-232 Cable Assembly A-3
Figure A-2 EIA/TIA-232 Cable Assembly A-4
Figure A-3 Dual Serial Module EIA/TIA-449 Cable Assembly A-6
Figure A-4 EIA/TIA-449 Four-Port Module Cable Assembly A-8
Figure A-5 Dual Serial Module V.35 Cable Assembly A-10
Figure A-6 Four-Port Serial Module V.35 Cable Assembly A-11
Figure A-7 Dual Serial Module X.21 Cable Assembly A-14
Figure A-8 Four-Port Serial Module X.21 Cable Assembly A-15
Figure A-9 Dual Serial Module EIA-530 Cable Assembly A-16
Figure A-10 Four-Port Serial Module EIA-530 Cable Assembly A-18
Figure A-11 Ethernet (AUI) Cable Assembly A-19
Figure A-12 RJ-45 10BaseT Connector A-20
Figure A-13 T1 Interface Cable A-22
To Next Page
Loading...
Need help?
General
