Name: Cisco FLUIDMESH FM4200 Mobi
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Device Fiber-

optic

module

installed

Idle @

115 Vac /

60 Hz

Idle @

230 Vac /

60 Hz

Full load

@ 115

Vac / 60

Full load

@ 230

Vac / 60

FM4500 Fiber No 9.889 9.889 26.598 26.257

Yes 12.958 12.958 29.326 29.326

FM4800 Fiber No 23.529 23.529 47.399 47.058

Yes 27.280 26.939 51.832 50.468

Cisco Ultra-Reliable Wireless

Backhaul FM4200 Mobi

Table of Contents3
Hazardous Condition Warnings7
Water Ingress Hazard8
Radio-Frequency Transmission Hazard9
Hot Surfaces Hazard10
Reporting Mistakes and Recommending Improvements11
Getting Started12
Introduction12
Cisco FM4200 Mobi12
The Cisco FM4200 Mobi Radio Transceiver12
Unit Function and Throughput Speed13
Data Throttling13
MPLS Protocol13
Unit Configuration13
Role Adaptability13
Environmental Rating13
Product Specifications14
Transceiver and Gateway Unit Power Consumption14
Fluidmesh Architecture15
Overview15
Wireless Network Architectures15
The Fluidmax TDMA Protocol15
Fluidmesh Technologies16
Prodigy16
FM Racer17
Point-To-Point Wireless Bridge17
Mesh Network Architecture18
Point-To-Multipoint Architecture with Fluidmax19
Fluidmesh Network Addressing21
Bridge IP Addressing21
Unit Identification and Addressing21
Mesh- and Bridge-Capable Radio Transceiver Identification21
Operating the Unit in Mesh Point Mode or Mesh End Mode22
Network Addressing23
Fluidmesh Radio Transceivers23
Connecting and Configuring an Ethernet Edge Device24
Fluidmesh Radio Transceivers24
Installing the Radio25
Installing the Radio Using Tie-Wraps or Hose Clamps25
Installation on a DIN Rail26
Installation Using the Sliding Bracket27
Hardware Installation29
Fluidmesh Hardware Installation29
Installing the Cisco FM4200 Mobi29
Environmental Rating and Unit Roles29
Installation Hardware29
Cisco FM4200 Mobi Status and Link Leds29
Unit and Link Quality Status29
Boot Sequence30
Supplying Power to the Cisco FM4200 Mobi30
Connecting Power to the Cisco FM4200 Mobi31
DC IN, LAN1/POE and LAN2 Ports31
Rebooting the Firmware and Resetting the Unit to Factory Defaults32
Device Firmware Reboot32
Resetting the Unit to Factory Settings32
Suitability for Outdoor Installation33
Connecting the Fluidmesh Cisco FM4200 Mobi to a Network and Antennas34
Terminal Assignments for Power and Data Connectors34
M12 A-Coded34
M12 A-Coded (Five-Pin)34
M12 A-Coded Eight-Pin (Pre-September 2016 Only)35
M12 X-Coded36
Connecting a DC in Power Source to the Unit37
Connecting LAN Cables to the Unit38
M12X LAN Cables38
Connecting the Antennas to the Cisco FM4200 Mobi40
QMA Antenna Connections40
Using the Fluidmesh Partner Portal43
Accessing the Partner Portal43
Enabling Two-Factor Authentication for Security44
Administering Plug-In License Codes46
Using the RACER™ Radio Configuration Interface46
Viewing the Technical Documentation for Your Fluidmesh Device46
Device Configuration Using the Configurator Interface48
Software and Hardware Prerequisites50
Accessing the Cisco FM4200 Mobi for Device Configuration50
Initial Configuration with the Unit in Provisioning Mode51
Switching between Offline and Online Modes56
Uploading a Device Configuration File from FM Racer57
General Settings59
The General Mode Window59
Changing the Operational Mode60
Changing the Operational Mode on a Mesh Network-Capable Unit60
Changing the Prodigy Version61
Changing the LAN Parameters62
Wireless Settings63
Modifying the Wireless Settings63
Important Considerations for Wireless Settings65
Point-To-Point and Point-To-Multipoint Considerations65
Co-Location Considerations66
Channel Width Considerations66
Dynamic Frequency Selection Considerations67
Antenna-Alignment Tools and Physical Statistics68
Spectral Analysis70
Network Control72
Ping Softdog72
Fm-Quadro74
FM-QUADRO for Mesh Network-Capable Devices74
Plotting and Interpreting the Wireless Links75
Viewing Live Data for a Radio or Wireless Link79
Viewing Live RSSI Data for a Wireless Link82
Manipulating the FM-QUADRO View83
Changing the Relative Position of Device Icons83
Showing KPI Values for Wireless Links84
Adding an Aerial Map to the FM-QUADRO View85
Adjusting the Transparency of the Aerial Map View86
Exporting a Network Representation File87
Advanced Tools88
Using the Ping Test Tool88
Using the Bandwidth Test Tool89
Using the Path MTU Discovery Tool90
Advanced Settings91
Advanced Radio Settings91
Using the Fluidmax Management Setting92
Using the Max TX Power Setting93
Using the Data Packet Encryption Setting93
Using the Maximum Link Length Setting94
Static Routes95
Pass Lists and Block Lists96
Multicast99
Multicast Management for Mesh Network-Capable Devices99
Configuring Multicast Within a Layer-3 Network102
SNMP Configuration103
Using SNMP V2C104
Using SNMP V3105
Wireless Access Point Configuration107
RADIUS Configuration111
NTP Configuration115
L2TP Configuration116
VLAN Settings117
VLAN Configuration117
Rules for Packet Management118
Fluidity Settings120
Handoff Logic and Rate Adaptation Settings123
Miscellaneous Settings124
Management Settings126
View Mode Settings126
Changing the Administrator Username and Password129
Enabling Remote Access to the Unit by Telnet130
Overwriting and Upgrading the Unit Firmware131
Plug-In Management133
The Device Status View137
The Device Status Window137
Saving and Restoring the Unit Settings139
Resetting the Unit to Factory Defaults141
Rebooting the Unit142
Logging out142
Viewing the End-User License Agreement143
Software Plug-Ins145
Available Plug-Ins145
Plug-In Management Procedures149
Plug-In Activation149
Deactivating an Active Plug-In151
Reactivating a Deactivated Plug-In154
Exporting and Uploading Multiple Activation Codes155
Sharing License Codes and Accepting Shared License Codes156
Troubleshooting158
I Cannot Get the Log-In Screen158
I Cannot Log in to the FM Racer Interface158
I Forgot the Administrator Password158
The Wireless Link Is Poor or Non-Existent in Bridge Mode159
Electrical Power Requirements160
Heat Radiation Data163
Federal Communications Commission (FCC) Radio Interference Statement165
Notices and Copyright168
Fluidmesh End-User License Agreement170
Preamble170
Notice170
Definitions170
License Grant171
Uses and Restrictions on Use171
Open-Source Software172
Termination173
Feedback173
Consent to Use of Data173
Warranty Disclaimer174
Limitation of Liability174
Exclusion of Liability for Emergency Services175
Export Control175
General176
Contact Us177

Questions and Answers:

Need help?

Do you have a question about the Cisco FLUIDMESH FM4200 Mobi and is the answer not in the manual?

Cisco FLUIDMESH FM4200 Mobi Specifications

General

Brand	Cisco
Model	FLUIDMESH FM4200 Mobi
Category	Transceiver
Language	English

Related product manuals

Cisco MGBBX1

10 pages

Cisco DWDM-XFP Series

28 pages

Cisco FLUIDMESH FM4200 Mobi User Manual

Table of Contents

Questions and Answers:

Cisco FLUIDMESH FM4200 Mobi Specifications

Related product manuals