DC IN, LAN1/POE And LAN2 Ports ............................................ 31
5.1.4. Rebooting The Firmware And Resetting The Unit To Factory
Defaults ............................................................................................... 32
Device Firmware Reboot ................................................................. 32
Resetting The Unit To Factory Settings ............................................. 32
5.1.5. Suitability For Outdoor Installation ................................................. 33
5.2. Connecting The Fluidmesh Cisco FM4200 Mobi To A Network And
Antennas .................................................................................................... 34
5.2.1. Terminal Assignments For Power And Data Connectors .................. 34
M12 A-Coded ................................................................................. 34
M12 A-Coded (Five-Pin) ............................................................ 34
M12 A-Coded Eight-Pin (Pre-September 2016 Only) ................... 35
M12 X-Coded ................................................................................. 36
5.2.2. Connecting A DC IN Power Source To The Unit ............................. 37
5.2.3. Connecting LAN Cables To The Unit ............................................. 38
M12X LAN Cables .......................................................................... 38
5.2.4. Connecting The Antennas To The Cisco FM4200 Mobi ................... 40
QMA Antenna Connections .............................................................. 40
6. Using The Fluidmesh Partner Portal ............................................................... 43
6.1. Accessing The Partner Portal ................................................................ 43
6.2. Enabling Two-Factor Authentication For Security .................................... 44
6.3. Administering Plug-In License Codes ..................................................... 46
6.4. Using The RACERâ„¢ Radio Configuration Interface ................................. 46
6.5. Viewing The Technical Documentation For Your Fluidmesh Device ........... 46
7. Device Configuration Using The Configurator Interface .................................... 48
7.1. Software And Hardware Prerequisites .................................................... 50
7.2. Accessing The Cisco FM4200 Mobi For Device Configuration .................. 50
7.2.1. Initial Configuration With The Unit In Provisioning Mode .................. 51
7.3. Switching Between Offline And Online Modes ......................................... 56
Uploading A Device Configuration File From FM Racer ............................ 57
7.4. General Settings ................................................................................... 59
7.4.1. The General Mode Window .......................................................... 59
Changing The Operational Mode ...................................................... 60
Changing The Operational Mode On A Mesh Network-Capable
Unit .......................................................................................... 60
Changing The Prodigy Version ......................................................... 61
Changing The LAN Parameters ........................................................ 62
7.4.2. Wireless Settings ......................................................................... 63
Modifying The Wireless Settings ...................................................... 63
Important Considerations For Wireless Settings ................................ 65
Point-To-Point And Point-To-Multipoint Considerations ....................... 65
Co-Location Considerations ............................................................. 66
Channel Width Considerations ......................................................... 66
Dynamic Frequency Selection Considerations ................................... 67
7.4.3. Antenna-Alignment Tools And Physical Statistics ............................ 68
7.4.4. Spectral Analysis ......................................................................... 70
7.5. Network Control .................................................................................... 72
7.5.1. Ping Softdog ................................................................................ 72
7.5.2. FM-QUADRO .............................................................................. 74
FM-QUADRO For Mesh Network-Capable Devices ........................... 74
Plotting And Interpreting The Wireless Links ..................................... 75
Viewing Live Data For A Radio Or Wireless Link ................................ 79
Viewing Live RSSI Data For A Wireless Link ..................................... 82
Manipulating The FM-QUADRO View ............................................... 83
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 4 of 177
To Next Page
Loading...
Need help?
General
