Figure 9. Protective rubber sleeves
Connect the antennas to the unit by doing the following steps:
1. The number and types of antennas to be connected to the unit
will have been decided at the network design stage. Verify which
antenna will be connected to each QMA plug.
2. Only remove the rubber sleeve from a QMA plug (above) if an
antenna must be connected to the plug.
Next, proceed to the steps in the following table:
Cisco Ultra-Reliable Wireless
Backhaul FM4200 Mobi
© 2020 Cisco and/or its affiliates. All rights reserved. Page 41 of 177
To Next Page
Loading...
Need help?
General
