Cisco FLUIDMESH FM4200 Mobi User Manual

Name: Cisco FLUIDMESH FM4200 Mobi
Brand: Cisco
Rating: 5 (1 reviews)

177 pages

To Next Page

To Previous Page

Figure 17. RACER™ Cloud connection info status (Disconnected)

Configure the unit by doing the following steps:

1. Click the Reset to Provisioning button at the bottom of the

DHCP fall-back configuration section.

2. Do a local (offline) configuration using the Configurator interface.

For further information, refer to “Device configuration using the

configurator interface” (page 48).

For a quick overview of the initial configuration process, refer to the

flowchart below.

NOTE

Each individual Fluidmesh radio transceiver unit has a factory-

set mesh identification number that takes the form 5.w.x.y.

If the unit's IP address is set to 169.254.x.y/24 as in Case 2

below, the values x and y represent parts x and y of the unit's

mesh identification number.

Cisco Ultra-Reliable Wireless

Backhaul FM4200 Mobi

Questions and Answers:

Need help?

Do you have a question about the Cisco FLUIDMESH FM4200 Mobi and is the answer not in the manual?

General