Cisco FM4200 - Using SNMP V2 C

To change the SNMP settings, do the following steps:
• Click the -snmp mode link under ADVANCED SETTINGS in the
left-hand settings menu.
• The default SNMP dialog will be shown (Figure 44 (page
117)).
Figure 44. SNMP dialog (SNMP disabled)
NOTE
By default, Cisco units are shipped from the
factory with SNMP disabled.
Using SNMP v2c
To change the unit's SNMP mode to v2c and configure the unit
accordingly, do the following steps:
Click the1. SNMP mode drop-down, and click the v2c option.
• The SNMP v2c settings dialog will be shown (Figure 45
(page 117)).
Figure 45. SNMP dialog (v2c selected)
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 117 of 189